Synthesis and design of polyurethane and its nanocomposites derived from canola-castor oil: Mechanical,thermal and shape memory properties

The recent global pandemic and its tremendous effect on the price fluctuations of crude oil illustrates the side effects of petroleum dependency more evident than ever. Over the past decades, both academic and industrial communities spared endless efforts in order to replace petroleum-based materials with bio-derived resources. In the current study, a series of shape memory polymer composites (SMPC's) was synthesized from epoxidized vegetable oils, namely canola oil and castor oil fatty acids (COFA's) as a 100% bio-based polyol and isophorone diisocyanate (IPDI) as an isocyanate using a solvent/catalyst-free method in order to eventuate polyurethanes (PU's). Thereafter, graphene oxide (GO) nanoplatelets were synthesized and embedded in the neat PU in order to overcome the thermomechanical drawbacks of the neat matrix. The chemical structure of the synthesized components, as well as the dispersion and distribution levels of the nanoparticles, was characterized. In the following, thermal and mechanical properties as well as shape memory behavior of the specimens were comprehensively investigated. Likewise, the thermal conductivity was determined. This study proves that synthesized PU's based on vegetable oil polyols, including graphene nanoparticles, exhibit proper thermal and mechanical properties, which make them stand as a potential candidate to compete with traditional petroleum-based SMPC's.     

Carbon Paste Composite with Co3O4 as a New Electrochemical Sensor for the Detection of Allura Red by Reduction

The detection of Allura red (AR) by electrochemical reduction using a different electrode from the conventional mercury electrode is presented. A carbon paste with cobalt (II, III) oxide composite electrode (CoO_x/CPE) is reported for the first time for the detection of AR. Moreover, others dyes such as tartrazine (TZ), sunset yellow (SY), amaranth (AM), Ponceaut 4‐R (P‐4R), and Sudan (SD) as well as pharmaceutical agents such as paracetamol (PMC) that are present in samples that contained AR did not show a reduced signal between 0.0 and ?0.3 V, which is the potential range where AR reduction was observed. The surface electroactivity was studied using cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and scanning electron microscopy (SEM). The presence of CoO_X increased the cathodic peak current for AR by more than 50 % and 65 % via CV and square wave voltammetry (SWV), respectively, compared with an unmodified carbon paste electrode. Under the optimal parameters, (pH=3.0, accumulation time (t_ACC)=60 s and accumulation potential (E_ACC)=0.50 V), the detection limit for AR was 0.05 μmol L^?1. The new sensor was sensitive and stable for the detection of AR. Moreover, it was easily manufactured and very convenient for food samples such as soft and isotonic drinks as well as chili sauce.     

Amides and Heparin‐Like Polymer Co‐Functionalized Graphene Oxide Based Core @ Polyethersulfone Based Shell Beads for Bilirubin Adsorption

Excessive bilirubin in the body of patient with liver dysfunction or metabolic obstruction may cause jaundice with irreversible brain damage, and new type of adsorbent for bilirubin is under frequent investigation. Herein, graphene oxide based core @ polyethersulfone‐based shell beads are fabricated by phase inversion method, amides and heparin‐like polymer are introduced to functionalize the core‐shell beads. The beads are successfully prepared with obvious core‐shell structure, adequate thermostability and porous shell. Clotting times and protein adsorption are investigated to inspect the hemocompatibility property of the beads. The adsorption of bilirubin is systematically investigated by evaluating the effects of contacting time, initial concentration and temperature on the adsorption, which exhibits improved bilirubin adsorption amount for the beads with amides contained cores or/and shells. It is worth believing that the amides and heparin‐like polymer co‐functionalized core‐shell beads may be utilized in the field of hemoperfusion for bilirubin adsorption.     

Mo (CO)6‐assisted Pd‐supported magnetic graphene oxide‐catalyzed carbonylation‐cyclization as an efficient way for the synthesis of 4(3H)‐quinazolinones

In this paper, a novel catalyst is introduced based on the immobilization of palladium on modified magnetic graphene oxide nanoparticles. The catalyst is characterized by several methods, including transmission electron microscopy, scanning electron microscopy, X‐ray fluorescence, vibrating‐sample magnetometer, Fourier transform‐infrared and dynamic light scattering (DLS) analysis. The activity of the catalyst was investigated in the synthesis of 4(3H)‐quinazolinones via Pd‐catalyzed carbonylation‐cyclization of N‐(2‐bromoaryl) benzimidamides by Mo (CO)₆. The Mo (CO)₆ is used as a carbon monoxide source for performing the reaction under mild conditions. The catalyst showed good reusability, and no change in activity was observed after 10 cycles of recovery.     

Synthesis of Seven-Membered Benzolactones by Nickel-Catalyzed C−H Coupling of Benzamides with Oxetanes

A NiCl₂(PEt₃)₂-catalyzed regioselective C−H coupling of 8-aminoquinoline-derived benzamides with oxetanes has been developed. The reaction proceeds with concomitant removal of the 8-aminoquinoline auxiliary to directly form the corresponding seven-membered benzolactones, which frequently occur in natural products and bioactive molecules. Additionally, no stereochemical erosion is observed during the course of the reaction, and the use of enantioenriched and substituted oxetane thus provides a new avenue to the optically active benzolactone.     

Activation of α-Fe2O3 for Photoelectrochemical Water Splitting Strongly Enhanced by Low Temperature Annealing in Low Oxygen Containing Ambient

Photoelectrochemical (PEC) water splitting is a promising method for the conversion of solar energy into chemical energy stored in the form of hydrogen. Nanostructured hematite (α-Fe₂O₃) is one of the most attractive materials for a highly efficient charge carrier generation and collection due to its large specific surface area and the short minority carrier diffusion length. In the present work, the PEC water splitting performance of nanostructured α-Fe₂O₃ is investigated which was prepared by anodization followed by annealing in a low oxygen ambient (0.03 % O₂ in Ar). It was found that low oxygen annealing can activate a significant PEC response of α-Fe₂O₃ even at a low temperature of 400 °C and provide an excellent PEC performance compared with classic air annealing. The photocurrent of the α-Fe₂O₃ annealed in the low oxygen at 1.5 V vs. RHE results as 0.5 mA cm⁻², being 20 times higher than that of annealing in air. The obtained results show that the α-Fe₂O₃ annealed in low oxygen contains beneficial defects and promotes the transport of holes; it can be attributed to the improvement of conductivity due to the introduction of suitable oxygen vacancies in the α-Fe₂O₃. Additionally, we demonstrate the photocurrent of α-Fe₂O₃ annealed in low oxygen ambient can be further enhanced by Zn-Co LDH, which is a co-catalyst of oxygen evolution reaction. This indicates low oxygen annealing generates a promising method to obtain an excellent PEC water splitting performance from α-Fe₂O₃ photoanodes.     

Engineering Lithium Ions Embedded in NiFe Layered Double Hydroxide Lattices To Activate Laminated Ni2+ Sites as High-Efficiency Oxygen Evolution Reaction Catalysts

NiFe layered double hydroxides (LDHs) have been denoted as benchmark non-noble-metal electrocatalysts for the oxygen evolution reaction (OER). However, for laminates of NiFe LDHs, the edge sites are active, but the basal plane is inert, leading to underutilization as catalysts for the OER. Herein, for the first time, light and electron-deficient Li ions are intercalated into the basal plane of NiFe LDHs. The results of theoretical calculations and experiments both showed that electrons would be transferred from near Ni²⁺ to the surroundings of Li⁺, resulting in electron-deficient properties of the Ni sites, which would function as “electron-hungry” sites, to enhance surface adsorption of electron-rich oxygen-containing groups, which would enhance the effective activity for the OER. As demonstrated by the catalytic performance, the Li−NiFe LDH electrodes showed an ultralow overpotential of only 298 mV at 50 mA cm⁻², which was lower than that of 347 mV for initial NiFe LDHs and lower than that of 373 mV for RuO₂. Reasonable intercalation adjustment effectively activates laminated Ni²⁺ sites and constructs the electron-deficient structure to enhance its electrocatalytic activity, which sheds light on the functional treatment of catalytic materials.     

Hierarchical Hollow-Nanocube Ni−Co Skeleton@MoO3/MoS2 Hybrids for Improved-Performance Lithium-Ion Batteries

Improving the performance of anode materials for lithium-ion batteries (LIBs) is a hotly debated topic. Herein, hollow Ni−Co skeleton@MoS₂/MoO₃ nanocubes (NCM-NCs), with an average size of about 193 nm, have been synthesized through a facile hydrothermal reaction. Specifically, MoO₃/MoS₂ composites are grown on Ni−Co skeletons derived from nickel–cobalt Prussian blue analogue nanocubes (Ni−Co PBAs). The Ni−Co PBAs were synthesized through a precipitation method and utilized as self-templates that provided a larger specific surface area for the adhesion of MoO₃/MoS₂ composites. According to Raman spectroscopy results, as-obtained defect-rich MoS₂ is confirmed to be a metallic 1T-phase MoS₂. Furthermore, the average particle size of Ni−Co PBAs (≈43 nm) is only about one-tenth of the previously reported particle size (≈400 nm). If assessed as anodes of LIBs, the hollow NCM-NC hybrids deliver an excellent rate performance and superior cycling performance (with an initial discharge capacity of 1526.3 mAh g⁻¹ and up to 1720.6 mAh g⁻¹ after 317 cycles under a current density of 0.2 A g⁻¹). Meanwhile, ultralong cycling life is retained, even at high current densities (776.6 mAh g⁻¹ at 2 A g⁻¹ after 700 cycles and 584.8 mAh g⁻¹ at 5 A g⁻¹ after 800 cycles). Moreover, at a rate of 1 A g⁻¹, the average specific capacity is maintained at 661 mAh g⁻¹. Thus, the hierarchical hollow NCM-NC hybrids with excellent electrochemical performance are a promising anode material for LIBs.     

Nickel sulphide-reduced graphene oxide composites as counter electrode for dye-sensitized solar cells: Influence of nickel chloride concentration

Nickel sulphide-reduced graphene oxide (NiS-rGO) composite films have been prepared via modified Hummers’s method assisted with spin coating technique. The NiS-rGO samples were then employed as counter electrode in a dye-sensitized solar cell (DSSC). The main aim of this work is to investigate the relationship between the concentrations of NiCl₂ with the properties of NiS-rGO and performance parameters of the device. The dominant rGO and minor NiS phase exist in the composite. The morphology of the composite is white strips rGO and NiS agglomerate particle. The element of C, O, Ni and S present in the composite. The highest η of 1.04% and J_sc of 7.39 mA cm⁻² were obtained from the device with 0.06 M NiCl₂ resulted from the longest carrier lifetime. The photovoltaic parameters results reveal that NiS-rGO composite has potential to become as a free platinum counter electrode of DSSC.     

Infrared spectroscopy of closed s-shell gas-phase M+(N2O)n (M = Li,Al) ion-molecule complexes*

ABSTRACT

We present the results of a combined experimental and computational study of the structures of gas-phase M⁺(N₂O)_n (M?=?Li, Al) complexes. Infrared spectra were recorded in the region of the N₂O asymmetric (N?=?N) stretch using photodissociation spectroscopy employing the inert messenger technique. Unlike in our previous studies on M⁺(N₂O)_n (M?=?Cu, Ag, Au and M?=?Co, Rh, Ir) complexes, N– and O–bound isomers in this case are near isoenergetic and are not distinguished spectroscopically at this resolution. In the case of Li⁺ complexes, there is, however, evidence for the presence of bound N₂ moieties, indicating the presence of inserted, OLi⁺N₂(N₂O)_n–type structures. The weak N₂ band lies to the blue of the signature of molecularly N– and O–bound ligands and is well–reproduced in the simulated spectra of energetically low-lying structures computed from density functional theory. No such inserted isomers are observed in the case of Al⁺(N₂O)_n complexes whose infrared spectra can be understood on the basis of molecularly-bound N₂O ligands. The differences in M⁺(N₂O)_n structures observed for these closed–shell, ns², metal centres relative to other metal cations are discussed in terms of the likely bonding motifs.